Knowledge Base

37DL Plus Temperature Compensation Mode

To accurately measure material thickness at elevated temperatures has always been difficult. A calibration carried out at room temp is not ideally suitable for measuring on material of a higher temp.Unless the gauge has Temperature Compensation ...
Omniscan Software Upgrade

This edition of knowledge base is to act as a tool to assist operators of the Omniscan MX to upgrade their unit to the latest version of the software...
Vantage Pencil Probe Set-up Procedure

The pencil probe is utilised pre weld inspection to x-check material compatibility...
Vantage Weldscan Probe Set-up Procedure

Ether NDE Vantage is an eddy current unit used to locate...